Program administrator Interview Questions
10K
Program Administrator interview questions shared by candidates
If an emergency arose during the first few days of employment and your immediate supervisor was off-site and unavailable, what would you do?
9 Answers↳
I will go to the next person above my Immediate Supervisor and notify them.
↳
I wil msg/ call to supervisor and inform her abt emergency I wil obey her advice. Less
↳
Because I'm prior service Military personnel I would contact the Security Supervisor on duty. And inform them of whatever was going on to see how the would to proceed with the emergency or non-emergency situation. Less
Would I give up my current permanent, long time job for a temp position?
8 Answers
tell me about your self
6 Answers↳
I basically told them about my background
↳
Arshad Mehmood
↳
I am from pakistan ,have valid passport also have heavy driving licence with 10 year experience Less
what are you expected about your salary?
6 Answers↳
12000 aed
↳
at that time i said i am looking for job, just net a opportunity.
↳
It can continue to support my family need.
Why would you like to work for Jacobs? Why this job?
5 Answers↳
I would like to exchange experience and have new challenge.
↳
I would like to work for the company because it has a lot of space to grow.
↳
Interviewed 6 FAANG employees and got this: bit.ly/faang100
Why are manhole covers round?
5 Answers↳
The answer they are undoubtedly looking for is because manholes are also round thus need round covers. It doesn't ask why they were designed to be round from an inventive stand point and makes no mention of why the holes themselves are round, just the covers. Its a test of your ability to use logic and reason and make sure that if they hired you that you would have a firm understanding of the "big picture". Thats my take on this anyway... Less
↳
My guess is if you need to put it back or take it off you can roll it around rather than carry it or drag it Less
↳
They aren't. In my house, there are 3, and they are all square or rectangular. I have been in a mine where the (round) manholes weren't covered with anything at all which was rather unsafe, and another where they were covered with a lattice to prevent things or people from falling into them. I haven't seen any round manhole cover yet. But I'm not a native English speaker and may not be getting the pun, someone please enlighten me what this stupid question means. Less
Job Experiences? Current Salary? Expected Salary? Notice Period? Why you want to switch? etc
5 Answers↳
General Answers
↳
How was your test?
↳
3 year experience current sallery 30k expected sallery 40k 1 month notice period
The interviewer asked me about my faith and religion. Upon telling him I did not want to discuss it the person quickly dismissed me in the conversation. It is obvious he is choosing just certain religions.
4 Answers↳
Wow, that is so unprofessional and despicable. I used to know the person you referenced and would be very disappoint if what you said is true. You should have contacted HR. Less
↳
thats a government violation
↳
You dodged a bullet there. They say they care about their employees but you are just warm bodies to them Less
There are two directly-connected switches. Assume that they communicate fine on the physical layer. Why can't two hosts with assigned addresses 192.168.100.5/30 and 192.168.100.50/30 communicate with each other? Also assume that network addresses can be used. How would you remedy this by swapping out only ONE of the devices on the network?
4 Answers↳
The hosts are on two different subnets. Replace one of the switches with a properly-configured router. Less
↳
the host which assign 192.168.100.5/30 and host 192.168.100.50/30 these subnet is not belong to same subnet Less
↳
The subnet being used only provides 2 useable address, .5 and .6 the .50 address is out of the range. If there are only switches and no router, swap out one switch with a router and re-configure the network addresses. Less
User has lost root password, how do you reset?
4 Answers↳
Boot in single mode by typing E on the selected the kernel in grub then add S or single or 1 to the end of line eg. then B to boot the selected kernel. once in the single-user mode disable SElinux with below command eg: setenforce 0 now using passwd command "With SElinux Off as Selinux will not let you change it" eg: [root@centos images]# passwd Changing password for user root. New password: your-password BAD PASSWORD: it is based on a dictionary word BAD PASSWORD: is too simple Retype new password: your-password passwd: all authentication tokens updated successfully. Less
↳
Actually the easiest way to do this is to single the box in run-level 1 then use the standard passwd tools to update the hash. That's far simpler than using a live cd and editing the shadow file. This a network based kvm. is an operation that can be done at the DC or over ipmi or Less
↳
init 1, change root password... I missed this one.