Related Job Search
{ "name": "search-interviews_300x250_right_bf//CA", "id": "div-AdSlot-l52quzf1", "fluid": true }
Power systems engineer Interview Questions
168
Power Systems Engineer interview questions shared by candidates
Power Systems Engineer was asked...November 27, 2020
Your experience on hybrid system
1 Answers↳
I present my practical and theorical knowledge on the subject
Senior Power Systems Engineer was asked...February 15, 2021
They asked me to limit my salary range between 50-55 which is inerasably low
1 Answers↳
I did not go below 60-70k and they reject me
Power Systems Engineer was asked...December 19, 2017
For a buck converter, how far below the switching frequency should the loop cross over frequency be?
1 Answers↳
10X lower.
Power Systems Engineer was asked...October 6, 2016
Power Systems Engineer was asked...September 6, 2019
Power Systems Engineer was asked...November 18, 2018
Power Systems Engineer was asked...August 3, 2015
I was given a map, illustrating a part of electricity network at the border of England and Scotland. The Scenario was loosing a 400 kV line and its subsequent effects on other 132 kV line and the connected network.The question was what should be done to decrease the effect of this outage? What lines or demands should be (probably) shut down? Explain the protection measures in such case.
1 Answers↳
I explained loosing one out of two big links will have an adverse effect
Power Systems Engineer was asked...May 23, 2012
Power Systems Engineer was asked...June 19, 2019
Power Systems Engineer was asked...December 19, 2017
Suppose you have a transconductance amplifer with infinite input impedance and transconductance Gm. There is a feedback resistor from output back to input (Rf). There is a load resistor from the output to Ground (RL) . Find the input impedance as a function of Gm, Rf, Rg.
1 Answers↳
start out with special cases. if Gm* RL = 1, then Vout = Vin and Zin = infinite. If Gm = 0, then Rin = RL+ Rout To get general solution, use KCL and KVL Less